Archipelago Monitor Statistics

Archipelago (Ark): CAIDA's active measurement infrastructure serving the network research community since 2007.
Statistical information for the topology traces taken by this individual Ark monitor is displayed below. See the main statistics page for the full list of monitors

yul2-ca

Zerofail
Montreal, QC, CA (6)

RTT quartiles vs hop distance

Use the following link to download the data used to render this graph in ASCII, comma-separated values format here: (CSV output)

Description

This graph shows the quartiles (25th, 50th, and 75th percentiles) of round-trip times (RTTs) found at each hop in a trace. This includes all probes, even ones that did not reach their destination. The y-axis cuts off values over 450ms, because of the occasional high-RTT result which skews the graph.

Motivation

By viewing the distribution of RTTs at each hop, we can gain a better sense of topological issues that contribute to high network latency.

Background

The round trip time for a (IP level) hop is the time (in milliseconds) that it takes for a packet to be sent from an Ark monitor to that hop and for that hop's response to be received by the monitor. Non-responding hops are ignored, and hops in a routing loop are removed.

Analysis

Typically, the first few hops are within the monitor's internal network and are very close to 0. Then there is usually a hop where the RTT values start to increase, and with each increasing hop, the range and median RTT values incrementally increase. The larger hops actually have decreased ranges of RTT values, because there are far fewer paths with that many hops in them. When a single hop has a large jump in the lower value of RTT, which no later hops go below, that typically indicates a slow (or heavily loaded) link common to many paths.